Selecting/Deleting A Job; Selecting A Job - Sokkia CX-52 Operator's Manual

28. SELECTING/DELETING A JOB

28.1 Selecting a JOB

Select the current JOB and Coordinate Search JOB.
• A total of 5 JOBs have been prepared, and JOB1 was selected when your CX
was shipped from the factory.
• The names of the JOBs have been preset as JOB1 to JOB5; you can change
them to any names you wish.
• Scale factor can be set for each JOB. Only scale factor of the current JOB can
be edited.

Current JOB
Measurement results, instrument station data, known points data, notes and
coordinate data are recorded in the current JOB.

Registering known point data: "29.1 Registering/Deleting Known Point
Data".

Coordinate Search JOB
The registered coordinate data in the JOB selected here can be read into
coordinate measurement, resection measurement, setting-out
measurement, etc.

Scale correction
CX calculates horizontal distance and coordinates of a point using
measured slope distance. If scale factor has been set, scale correction is
carried out during calculation.
Corrected horizontal distance (s) = Horizontal distance (S) ×
Scale factor (S.F.)
• When scale factor is set to "1.00000000", the horizontal distance is not
corrected.

Horizontal distance: "31.1 Configuration -Config Mode-"
Observation Condition
PROCEDURE JOB selection and scale factor setting
1. Select "JOB" in Data Mode.
208

Horizontal distance (H Dist)
Data
JOB
Known data
Code