9. Sight the first point and press
[OBS].
The measurement results are
displayed on the screen.
• Press [STOP] to stop the
measurement.
• You can input target height here.
10. Press [YES] to use the
measurement results of the first
point.
• Press [NO] to observe the first
point again.
11. Sight the second point and press
[OBS].
12. Press [YES] to use the
measurement results of the
second point.
The distance between the two
measured points, the distance
calculated from inputting the
coordinates of two points and the
scale factors are displayed.
13. Press [OK] on the screen of step
13 to define the baseline. <Set-out
line> is displayed. Move to setting-
line measurement.
"15.2 Setting-out Line Point"/
"15.3 Setting-out Line Line"
• Press [Sy=1] to set scale factor
y to "1".
• Press [1 : **] to change the
grade display mode to "1 : * * =
elevation : horizontal distance".
15. SETTING-OUT LINE
M e a s u r e 1 s t P t .
1 1 3 . 4 6 4
N
9 1 . 0 8 8
E
1 2 . 1 2 2
Z
OBS
Measure
Tgt.h
EDIT
A z i m u t h 9 3 ˚ 2 0 3 1
13.003m
H c a l c
13.004m
H m e a s
1.000091
S c a l e X
S c a l e Y 1.000091
Sy=1
Sy=Sx
EDIT
% - 2 . 6 6 9
G r a d e
1:**
S e t - o u t l i n e
P o i n t
L i n e
=
1st Pt.
1.400m
NO
YES
OK
%
OK
69