ECN-360A-HM65 Em b e d d e d S ys te m
S te p 5:
Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
NOTE:
To have the best system heat dissipation, please make sure to face the
I/O panel downward (Figure 3-5) when mounting the system.
Insert four retention screws, two in each bracket, to secure the system to the
S te p 6:
wall.
S te p 0:
3.6 Exte rn a l P e rip h e ra l In te rfa c e Co n n e c to rs
The following external peripheral devices can be connected to the external peripheral
interface connectors.
Audio devices
HDMI devices
RJ-45 Ethernet cable
Serial devices
USB devices
VGA monitor
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding ECN-360A-HM65 external peripheral interface connector
making sure the pins are properly aligned.
3.6.1 Au d io Co n n e c tio n
The audio jack on the external audio connector enables the ECN-360A-HM65 to be
connected to a stereo sound setup. To install the audio devices, follow the steps below.
Identify the audio plugs. The plugs on your home theater system or speakers
S te p 1:
may not match the colors on the rear panel. If audio plugs are plugged into the
wrong jacks, sound quality will be very bad.
P a g e 17