SUPPLY CONNECTIONS
ELECTRICAL SUPPLY
This heater has a 1.5 m power cord with a three pin plug supplied. The power cord passes through a slot in the
front right hand side of the appliance, approximately 140 mm from the front of the unit.
If a power point is used it MUST be 230 V, rated at 10A and MUST be earthed.
This power point MUST NOT be located above the heater and a switch provided to electrically isolate the
appliance for servicing.
Direct Wired Installations
Alternatively the appliance can be direct wired to conceal the power supply.
A qualified electrician will need to be consulted where a direct wired installation is required.
A switch is to be provided to electrically isolate the appliance for servicing.
Any such installation must comply with the requirements of AS/NZS 5601, AS/NZS 3000 and any
IMPORTANT
other relevant local regulations.
Rinnai
approx.
140 mm
16
RHFE0800F_1000_1500 IM