Table of Contents
Advertisement
WALL LINING INSTALLATION
EDGE FINISHING OPTIONS
(applicable to any installation method)
Rinnai optional
Finishing Trim, only suitable
where wall lining is at least 1mm
set back from front face of fire
Wallboard cut out A
Cut-out size B
With this bigger gap there is a risk that the
wallboard support panel and the finishing
trim clips will be visible.
Consider this before utilising this method
Rinnai
Adhesive is recommended in
place of screws as permanent
fixing across the top of the fire
A (1 : 1)
with optional Rinnai Finishing Trim
Cut-out size C
with 3 x 8 recess
A (1:1)
with wallboard edge finish
(no plaster or trim finish)
30
Wallboard Support MUST
be used for combustible wallboard and is
designed for wallboard thicknesses of 10,
13, and 20 mm allowing for 1 mm setback
for the Finishing Trim or plaster finish
Finishing Trim
latch
A
Finishing Trim
8
A (1:1)
with rebated wallboard edge finish
This method will produce a
closer fit to the fire but
does make the front edge
vulnerable to damage
RHFE0800F_1000_1500 IM
Advertisement
Table of Contents
