Table of Contents
Advertisement
Electrical supply
The Novo is supplied with a power cord (length 1500 mm) and a 3-pin plug. The standard electrical
connection passes through the rear panel, but can also pass through the left or right hand side
of the unit by removing the knockout tab from the bottom edge of the front panel. If changing the
electrical position use the rubber grommet from the rear of the appliance for cable protection.
The connection is either direct wired* or connected
to a power point within the cavity. This must be
connected to a dedicated 240 V, 10 A earthed
power point. The electric isolation switch must be
accessible after the appliance has been installed.
The heater must not be located immediately below a
socket outlet (potential fire hazard).
The power cord is not fire rated and should not
come into contact with the unit. If the power cord
is damaged, it must be replaced by a licensed
tradesperson. This must be a genuine replacement
part available from Rinnai.
Using an existing externally mounted power point
If you already have an existing power point outside the enclosure, you can redirect the power cord
through the LHS or RHS of the front panel. With the frame removed redirect the cord and plug
(with the grommet), underneath the unit and to the front (left or right).
Remove the pre-punched metal knock-out located in the lower left or right edge of the frame,
ensuring the grommet is fitted to the metal knock-out. Excess cord may be left in the cavity below
the unit—DO NOT coil excess cord.
* Consult a qualified electrician if direct wiring is required as it must comply with AS/NZS 5601 and AS/NZS 3000 and
other relevant local regulations
Novo DV inbuilt installation guide: 13748-C 03-22 | 13
Advertisement
Table of Contents
