Table of Contents
Advertisement
V1410 / V1412 User Manual
Microstream CO2 Messages
Messages – Measurement Mode
Message
INITIALIZATION
FILTERLINE NOT
CONNECTED
AUTO ZERO IN PROGRESS
CO2 VALUE OVER RANGE
MESUREMENT MODE
90
Initializing the EtCO2 Module when power on. It doesn't measure
during this time.
The filter line is not connected to the EtCO2 accessory.
Zeroing the EtCO2 Module by itself. The EtCO2 waveform and
value are not displayed during this time.
It will start auto-zeroing after starting, and at 5, 10, 15, 30, 60
minute intervals and after that, every 60 minutes. During the
warming-up (minimum 20 minutes), it starts auto zeroing < 15
seconds, if it is necessary. Auto zeroing starts at over 8 ◦C or over
5mmHg of pressure change from last zeroing.
The CO
value is out of range.
2
Range: 0- 99mmHg / 0-13.2% / 0-13.2kPa
Wait for EtCO2 measurement with connecting to the accessory.
Description
Advertisement
Table of Contents
