Table of Contents
Advertisement
ECG Lead Change
1
Change the ECG2 and ECG3 lead waveform settings using the same method used in Step 1,
2
except select CH 2 and then
3
By operating as detailed above, you can select each function of the ECG mode.
Setting
Mode
LEAD
GAIN
SPEED
CABLE
NOTCH
FILTER
CONFIG
ARRHYTHMIA
PACEMAKER
HR CALC.
DEFIB. SYNC
CH3.
Range
LEAD I, II, III, aVR, aVL, aVF, V1 - V6
2.5, 5, 10, 20, 30, 40 mm/mV, AUTO
6.25, 12.5, 25, 50 mm/sec
3 LEAD, 5 LEAD
START, STOP
AREA
50Hz, 60 Hz
0.5 – 40 Hz
0.5 – 80 Hz
0.05 – 40 Hz
0.05 – 80 Hz
MONITORING
J + 0, 20, 30, 40,
ST
50, 60, 70, 80 ms
START, STOP
START, STOP
ON / OFF
To change the ECG1 lead waveform setting, press
Menu button one time on the Main screen.
Select ECG LEAD CH 1 and then select the
lead.
Sets the type of ECG lead.
Sets the size of the ECG wave.
Sets the velocity of the ECG wave.
Sets the type of ECG cable.
Synchronizes the monitor with the frequency of
the power being supplied.
Establishes the frequency being used by the
monitor's power input.
Sets the analog and digital filter for the ECG
wave.
Sets the J point.
Sets the usage of arrhythmia analysis.
Sets the detection of the pacemaker.
4 – 16
Sets parameters to compare for the HR Calc.
Sets synchronization when using ECG OUT.
V1410 / V1412 User Manual
Description
57
Advertisement
Table of Contents
