Etco2 Measurement (Optional); Etco2 Measurement Screen - Vetland V1410 User Manual

39. EtCO2 Measurement (Optional)

Microstream, mainstream, and sidestream CO
microstream CO module provides the function of EtCO2 and the function to measure respiratory CO
2
and respiration numbers using the small filter line based on a small lumen-type filter line. In the
microstream CO type, the level is measured through the cannula (non-tubing type) attached to the nose
2
or a sampling line equipped in the respiratory circuit (tubing type).

The EtCO2 measurement utilizes a 50 ml/min sampling rate. The monitor should not be
attached to patients that may become distressed with a 50 ml/min reduced inspiratory
volume.

The sampling outlet of the V1410 / V1412 should be attached to an active scavenging
WARNING
system to evacuate the anesthetic gases discharged by the patient.

The gas inspiring vacuum pressure (negative pressure) of the gas elimination system should
not exceed the pump outlet standard of the V1410 / V1412, 1.0 mmHg. Excessive pressure
will display an OCCULSION message and it may damage the V1410 / V1412 pump. During
zeroing, the air elimination system should be operating.
CAUTION

Sampling lines and filters may become contaminated with patient bodily fluids. Use proper
protocols when handling such lines and accessories.

The monitor zeros the CO
sample lines to the CO

Range of Respiration Measuring: 0 – 150 bpm

For the best accuracy, a warm-up of about 20 minutes is required.
NOTE

It is optional to use 5% gas for calibration and the microstream filter line

EtCO2 Measurement Screen

No.
1 CO Waveform
2
2 CO Waveform Speed
2
3 CO Waveform Size
2
4 Message Indicator
modules can be connected to the V1410 / V1412. The
2
sensor during the power-up self test. Do not allow connection of
2
source during the self test period.
2
Description
V1410 / V1412 User Manual
No. Description
5 FiCO2
6 Respiration Measuring
7 EtCO2
2
87