Installing The X330-28Gtx Switch; Figure 42: Attaching The Equipment Rack Brackets To The X330-28Gtx Switch - Allied Telesis x330 Series Installation Manual

Installing the x330-28GTX Switch

This section contains the procedure for installing the x330-28GTX Switch
in a standard 19-inch equipment rack with the two equipment rack
brackets included with the device. Here are the required items:
Two equipment rack brackets (included with the switch).

Six M4x8mm bracket screws (included with the switch).

Cross-head screwdriver (not provided).

Four standard equipment rack screws (not provided).

To install the x330-28GTX Switch in a 19-inch equipment rack, perform the
following procedure:
1. Place the switch on a table.
2. Attach the equipment rack brackets to the sides of the switch with the
six 4x8mm screws included with the device. Refer to Figure 42.
Figure 42. Attaching the Equipment Rack Brackets to the x330-28GTX
3. Have another person hold the switch at the selected location in the
equipment rack while you secure it using four standard equipment rack
screws (not provided). Refer to Figure 43 on page 88.
4. Go to Chapter 7, "Displaying the Hardware Status and AlliedWare Plus
Version Number" on page 99.
x330 Series Installation Guide for Virtual Chassis Stacking
Switch
87