The Dstream-St Unit - ARM DSTREAM-XT Getting Started Manual

DSTREAM-XT Getting Started Guide
• Ethernet cable
(Not pictured)
• USB 3.0 cable
(Not pictured)
Related information
Connect and power up the DSTREAM-XT system

2.3 The DSTREAM-ST unit

The DSTREAM-ST unit provides the hardware interface to connect the host computer to your
target.
Rear
The rear of the DSTREAM-ST unit contains ports for connecting to the network, host computer,
and the power source. It also contains the RESET button and the USER IO port.
Figure 2-15: Rear of the DSTREAM-ST unit
Ethernet port USB 3.0 port
Ethernet port
If you want to access your DSTREAM-ST unit over a local area network, use the Ethernet
port.
The green LED indicates that the Ethernet link is up and running. The yellow LED indicates
that activity is taking place. Supported data rates are: 10/100/1000 Mbps.
DSTREAM-ST is a Gigabit Ethernet (GbE) device. To achieve the maximum GbE data transfer
rate:
• Your host computer must support the GbE standard.
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
on page 26
User IO port
Non-Confidential
Document ID: 102443_1.0_00_en
Version 1.0
The DSTREAM-XT system
Reset button Power input
Page 16 of 38