Danfoss VLT AutomationDrive FC 301 Series Design Manual page 148

Electrical Installation
Leakage current [mA]
Figure 9.40 The Influence of the Cut-off Frequency of the RCD
9 9
on What Is Responded to/Measured
9.6 Additional Connections
9.6.1 Relay
Relay 1
•
Terminal 01: common
•
Terminal 02: normal open 240 V
•
Terminal 03: normal closed 240 V
Relay 2 (Not FC 301)
•
Terminal 04: common
•
Terminal 05: normal open 400 V
•
Terminal 06: normal closed 240 V
Relay 1 and relay 2 are programmed in 5-40 Function Relay,
5-41 On Delay, Relay and 5-42 Off Delay, Relay.
Additional relay outputs by using Relay Option Module
MCB 105.
146
Design Guide
100 Hz
2 kHz
100 kHz
Figure 9.41 Relay Outputs 1 and 2
To set the relay output, see parameter group 5-4* Relays.
No.
Table 9.18 Description of Relays
Figure 9.42 Terminals for Relay Connection
(Enclosure Types A1, A2 and A3).
Rev. 2014-04-04 All rights reserved.
01-02 make (normally open)
01-03 break (normally closed)
04-05 make (normally open)
04-06 break (normally closed)
MG33BF22