Hazard Lamp Answerback Adjustment - Mitsubishi Pajero Pinin 1999 Workshop Manual

42-40

HAZARD LAMP ANSWERBACK ADJUSTMENT

The following functions can be adjusted by operating input switches. The adjustments will be stored in
the ECU memory even after a battery cable is disconnected:
Switching of keyless entry answerback function (From activation to desactivation, or viceversa)
Initialization of all the ETACS functions (From desactivation to activation)
1. Entry conditions to the adjustment mode
The ETACS-ECU sounds a buzzer once when all of the following conditions are satisfied, and then
enters the adjustment mode:
Hazard warning lamp switch: OFF
Diagnosis control: ON (Connect the MUT- II or earth the diagnosis connector No.1 terminal.)
Key reminder switch: OFF
Ignition switch: LOCK (OFF)
Driver's door switch: OFF (Close the driver's door.)
If all of the conditions above are satisfied, the windshield washer switch will be turned on for
more than 10 seconds.
2. Exit conditions from the adjustment mode
The ETACS-ECU cancels the adjustment mode when any of the following conditions is satisfied:
Diagnosis control: ON (Disconnect the MUT- II or disconnect the diagnosis connector No.1 terminal
from the earth.)
Key reminder switch: ON (Pull out the ignition key.)
Ignition switch: Other than LOCK (OFF)
Driver's door switch: ON (Open the driver's door.)
After the ETACS-ECU has entered the adjustment mode, no adjustment is made within 3 minutes
(If any adjustment is made within 3 minutes, the ETACS-ECU monitors a adjustment operation
for other 3 minutes.)
Other warning buzzer(s) sounds
BODY ±
Keyless Entry System
8. Registration mode will be terminated under the following
conditions.
When the encrypted codes for four transmitters have
been registered;
When one minute has passed after registration mode
started;
When the MUT- II is disconnected (earth is released);
When the ignition key is removed;
9. After registration mode has been completed, carry out
the followings to make sure that the keyless entry system
operates.
Pull the ignition key out.
Close all of the doors.