Mitsubishi Pajero Pinin 1999 Workshop Manual page 707

52B-40
SRS ±
Air Bag Modules and Clock Spring
A D PASSENGER'S AIR BAG MODULE REMOVAL
Caution
The removed air bag module should be stored in a clean,
dry place with the deployment surface facing up.
A E FRONT SEAT BACK ASSEMBLY REMOVAL
Refer to GROUP 52A ± Seat.
Caution
1. When the side air bag module is required replacing,
replace the front seat back assembly.
2. The removed front seat back assembly should be
stored in clean, dry place with its back touching the
ground.
INSTALLATION SERVICE POINTS
A A PRE-INSTALLATION INSPECTION
1. Even new air bag modules and a clock spring require
inspection before installation. (Refer to P.52B-41.)
Caution
When discarding the air bag module or seat back
assembly, deploy the air bag as specified in the service
procedure. (Refer to P.52B-48.)
2. Connect the negative (±) battery terminal.
3. Connect the MUT- II to the diagnosis connector (16-pin).
Caution
Turn the ignition switch to LOOK (OFF) position when
connecting and disconnecting the MUT- II .
4. Turn the ignition switch to ON.
5. Read a diagnostic code to Refer to that the SRS is operating
properly except an open in the air bag module circuit.
6. Turn the ignition switch to LOCK (OFF) position.
Disconnect the negative (±) battery cable and insulate
with tape.
Caution
Wait at least 60 seconds after the disconnection of the
battery cable before any further job. (Refer to P.52B-4.)
B A CLOCK SPRING INSTALLATION
Align the mating marks on the clock spring as mentioned in
the next step. Then, after putting the front wheels in
straight-ahead position, install the clock spring to the column
switch.