Mitsubishi Pajero Pinin 1999 Workshop Manual page 487

35A-20
FRONT DISC BRAKE
REMOVAL AND INSTALLATION
Pre-removal Operation
Brake Fluid Draining
90 ± 110 Nm
Removal steps
1. Brake hose connection
2. Gasket
A A 3. Disc brake assembly
4. Brake disc
MB991000
(MB990998)
BASIC BRAKE SYSTEM ±
49 Nm
INSTALLATION SERVICE POINT
A A DISC BRAKE ASSEMBLY INSTALLATION
1. In order to measure the brake drag force after pad
Bolt
2. Install the caliper support to the knuckle, and then assemble
Front Disc Brake
Post-installation Operation
Brake Fluid Supplying and Air Bleeding
(Refer to P.35A-10.)
2
4
installation, measure the rotary-sliding resistance of the
hub by the following procedure with the pads removed.
(1) Withdraw the drive shaft. (Refer to GROUP 26 ± Front
Axle.)
(2) Attach the special tool to the front hub assembly as
shown in the illustration, and tighten it to the specified
torque.
Tightening torque: 196 ± 255 Nm
(3) Use a spring balance to measure the rotary-sliding
resistance of the hub in the forward direction.
the pad clip and the pad to the caliper support.
Caution
Do not contaminate the friction surfaces of the pads
and brake discs by any oil or grease.
1
2
3