Hazard Warning Lamp Switch; Rheostat Control Switch; Van Body Dome Light Switch - Mitsubishi FUSO FE 2006 Owner's Manual

5-22
Switches and controls
Bright
Dim

Hazard warning lamp switch

CAUTION
The battery may be discharged and the engine
impossible to restart if the hazard warning
lamps are operated for an extended period of
time.
The hazard warning lamps may be used as a warn-
ing to other vehicles when you suddenly find it nec-
essary to stop your vehicle in emergencies.
The lamps can flash in any of the starter switch
positions.
Pressing switch causes all turn signal lamps to flash
simultaneously. At the same time, indicator lamps
start flashing.
Pressing the switch again causes the lamps to go
out.
Z10816
Use the rheostat control switch to adjust the bright-
ness of the meter cluster illumination lamps.
With the meter cluster lamps on, press and hold
either side of the switch to set the lamps to your
desired brightness, then release the switch.
Z11866 NOTE:
The lamps can be brightened and dimmed only
within a fixed range. Pressing the rheostat control
switch after the lamps have brightened or dimmed
to the limit will have no effect.

Van body dome light switch

<Vehicles other than Crew-cab models>
This switch operates the lighting inside the van
body. With the starter switch in the "ON" position,
operate the van body dome light switch to turn the
van body interior lighting on or off. An indicator light
comes on in the switch when it is in the "ON" posi-
Z11867
tion.
CAUTION
Leaving the van body interior lighting on for an
extended period without the engine running can
drain the battery.

Rheostat control switch