Mitsubishi Pajero Pinin 1999 Workshop Manual page 435

216 Nm
MB990850
MB990685
Identification
colour
REAR AXLE ±
2. Use the special tool to hold the companion flange, and then
tighten the companion flange self-locking nut to the
specified torque.
3. Use the special tool to measure the drive pinion turning
MB990326
torque (without the oil seal).
Standard value:
4. If the drive pinion turning torque is not within the standard
value, adjust the turning torque by replacing the drive
pinion front shim(s) or the drive pinion spacer.
NOTE
When selecting the drive pinion front shims, if the number
A
of shims is large, reduce the number of shims to a minimum
by selecting the drive pinion spacer.
Select either of the following drive pinion spacers.
5. Remove the companion flange and drive pinion once again.
Insert the drive pinion front bearing inner race into the
differential carrier, and then use the special tool to tap
MB990727
in the oil seal into the differential carrier.
Differential Carrier
Bearing Bearing lubrication
New None
(with anti-rust agent)
New or reusing Gear oil applied
Height (A) of drive pinion spacer mm
56.67
57.01
27-23
Turning
torque Nm
0.59 ± 0.88
0.39 ± 0.49
Identification colour
±
White