Heater Unit, Blower Unit, Resister And Evaporator - Mitsubishi Pajero Pinin 1999 Workshop Manual

55-22
HEATER, AIR CONDITIONER AND VENTILATION

HEATER UNIT, BLOWER UNIT, RESISTER AND EVAPORATOR

REMOVAL AND INSTALLATION
Caution: SRS
When removing and installing the floor console assembly from vehicles equipped with SRS, do
not let it bump against the SRS-ECU or the components.
1
2
3
Heater unit and blower unit removal steps
Discharging
Refrigerant (Refer to P.55-10.)
Discharging and Charging of Engine
Coolant (Refer to GROUP 14 ±
On-vehicle Service.)
Engine Cover Removal and Installa-
tion (Refer to GROUP 11 ± Engine
Assembly.)
Air Cleaner Assembly Removal and
Installation.
Front Scuff Plate, Rear Scuff Plate,
Cowl Side Trim and Glove Box
Removal and Installation (Refer to
GROUP 52A ± Trims.)
Front Seat Assembly (Driver's side)
Removal and Installation (Refer to
GROUP 52A ± Seat.)
Shift Lever Assembly Removal and
Installation (Refer to GROUP 22 ±
Transmission Control.) <M/T>
5
and Charging
Heater Unit, Blower Unit,
±
Resister and Evaporator
9
6
4
of
1. Instrument panel assembly
2. Intermediate connector
3. Antenna feeder cable connection
4. DIN cable
5. Rear heater duct B
6. Rear heater duct A
7. Heater hoses connection
8. Refrigerant line connection
9. Blower unit, heater unit and deck
Piping connection
8
ring
Compressor
ZXL 200PG
7
8
2
Selector Lever Assembly Removal
and Installation (Refer to GROUP 23
± Transmission Control.) <A/T>
SRS±ECU (Refer to GROUP 52B.)
Floor Carpet Removal and Installation.
(Refer to GROUP 52A.)
connections
crossmember assembly
oil: