Front Impact Sensors - Mitsubishi Pajero Pinin 1999 Workshop Manual

52B-32

FRONT IMPACT SENSORS

Caution
1. Disconnect the battery (±) terminal and wait
for 60 seconds or more before starting work.
Furthermore, the
terminal should be covered with tape to
insulate it. (Refer to P.52B-4.)
2. Never attempt to disassemble or repair the
front impact sensor. If faulty, replace it.
REMOVAL AND INSTALLATION
Pre-removal Operation
D
Turn Ignition Key to LOCK (OFF) position.
D
Disconnect the Negative (±) Battery Terminal.
4.9 Nm
2
Removal steps
1. Under cover
2. Front impact sensor
SRS ±
Front Impact Sensors
disconnected battery
Front side member
1
INSTALLATION SERVICE POINTS
A A PRE-INSTALLATION INSPECTION
To mount the new front impact sensor, visually check it and
measure the resistance between the terminals. (Refer to the
previous item ªINSPECTIONº)
3. Do not drop or subject the front impact
sensor to impact or vibration.
If denting, cracking, deformation, or rust are
discovered in the front impact sensor,
replace it with a new front impact sensor.
Discard the old one.
4. After deployment of an air bag, replace the
front impact sensor with a new one.
Installation steps
A A D Pre-installation inspection
B A 2. Front impact sensor
1. Under cover
D Negative (±) battery cable connection
C A D Post-installation inspection