Starting System; General Information; Service Specifications - Mitsubishi Pajero Pinin 1999 Workshop Manual

STARTING SYSTEM

GENERAL INFORMATION

If the ignition switch is turned to the ªSTARTº
position, current flows in the pull-in and holding coils
provided inside magnetic switch, attracting the
plunger. When the plunger is attracted, the lever
connected to the plunger is actuated to engage
the starter clutch.
On the other hand, attracting the plunger will turn
on the magnetic switch, allowing the B-terminal and
SYSTEM DIAGRAM
Ignition
switch
Battery
STARTER MOTOR SPECIFICATIONS
Items
Type
Rated output kW/V
No. of pinion teeth

SERVICE SPECIFICATIONS

Items
Pinion gap mm
Commutator outer diameter mm
Commutator runout mm
Commutator undercut mm
ENGINE ELECTRICAL ±
Brush
Standard value
0.5 ± 2.0
29.4
±
0.5
Starting System
M-terminal to conduct. Thus, current flows to engage
the starter motor.
When the ignition switch is returned to the ªONº
position after starting the engine, the starter clutch
is disengaged from the ring gear.
An overrunning clutch is provided between the pinion
and the armature shaft, to prevent damage to the
starter.
Holding coil
Pull-in coil
Armature
Yoke
Specifications
Reduction drive with planetary gear
1.2/12
8
Limit
±
28.8
0.05
0.2
16-17
Plunger
Lever
Over-running
clutch
Pinion shaft