Mitsubishi Pajero Pinin 1999 Workshop Manual page 592

Glass stopper installation holes
Concavity
Dual lock fastener
BODY ±
Window Glass
REMOVAL SERVICE POINT
A A
BACK DOOR GLASS REMOVAL
Remove the back door glass in the same manner as for the
windshield. (Refer to P42-11.)
INSTALLATION SERVICE POINT
A A
WINDOW DAM/DUAL LOCK FASTENER/GLASS
STOPPER/BACK DOOR GLASS INSTALLATION
1. Use a isopropyl alcohol to decrease the glass and body
surfaces where the window dam, dual lock fasteners and
glass stoppers are installed.
2. Install the window dam.
3. Install the dual lock fasteners to the concavities on the
body panel and the glass stoppers to the hole on the
Concavity
body panel respectively.
4. Install the dual lock fasteners to the windshield in the
positions corresponding to the ones on the body panel
where the dual lock fasteners have been installed.
5. Apply the primer and adhesive.
6. Install the glass in the same manner as for the windshield.
(Refer to P.42±12.)
42-17