Mitsubishi Pajero Pinin 1999 Workshop Manual page 834

CHASSIS ELECTRICAL ±
Error Code No. 1092, 1093, 1094, 1095, 1096
Is a CD-ROM for this navigation system inside?
Is the CD-ROM inserted upside down?
Is the disc dirty, damaged or iced up?
Repeat the wiring check. If the same problem occurs, there is
a malfunction of the CD drive within the navigation unit.
Error Code No. 10A1, 10B1
Were the wiring check instructions followed?
Repeat the wiring check. If the same problem occurs, there is
a malfunction of the memory within the navigation unit..
Error Code No. 20D1, 30D1
Were the sensor check instructions followed?
Check connector (B-08, C-50).
Measure at the navigation unit connector B-08.
Disconnect connector.
Turn on the Ignition switch and then move the vehicle slowly.
Voltage between terminal (4) and body eartth.
OK: HI: 4 ± 5 V, Lo: 0 ± 1 V, pulse signal
Replace the navigation unit.
Error Code No. 20E1, 20E2, 30E1, 30E2
Were the sensor check instructions followed?
Repeat the sensor check. If the same problem occurs, there is
a malfunction of Gyro sensor within the navigation unit.
YES
NO
NO
YES
YES
OK
OK
YES
Multi-Center Display <High Grade>
NO
Insert the CD-ROM for this navigation system.
YES
Insert the CD-ROM correctly.
YES
Repair or replace the disc.
Replace the navigation unit.
NO
Repeat the wiring check.
Replace the navigation unit.
NO
Repeat the sensor check.
NG
Repair
NG
Check the vehicle speed sensor. (Refer to P.54A-27.)
NO
Repeat the sensor check.
Replace the navigation unit.
54A-107