Mitsubishi Pajero Pinin 1999 Workshop Manual page 833

54A-106
CHASSIS ELECTRICAL ±
Error Code No. 1021
Were the wiring check instructions followed?
Repeat the wiring check. If the same problem occurs, measure
at the multi-center display connector C-52.
Disconnect connector.
Ignition switch: ON
Voltage between terminal (33) and body eartth.
OK: 0.1 V (full tank full) ± 3 V (fuel empty)
Replace the multi-center display.
Error Code No. 1031
Were the wiring check instructions followed?
Repeat the wiring check. If the same problem occurs, there is
a malfunction of the GPS inside the multi-center display.
Error Code No. 1041
Were the wiring check instructions followed?
Connect MUT- II and diagnose engine.
Replace the multi-center display.
Error Code No. 1051
Were the wiring check instructions followed?
Check connector (C-53, C-83)
Check SWS diagnosis trouble code.
Replace the multi-center display.
Error Code No. 1091
Is the navigation unit very hot because of direct sunlight, heat
air, etc.?
Repeat the wiring check. If the same problem occurs, there is
a malfunction of the CD drive within the navigation unit.
YES
OK
YES
YES
OK
YES
OK
OK
NO
Multi-Center Display <High Grade>
NO
Repeat the wiring check.
NG
Check the harness between C-52 and D-17.
NO
Repeat the wiring check.
Replace the multi-center display.
NO
Repeat the wiring check.
NG
Check the harness between C-53 and C-19.
NO
Repeat the wiring check.
NG
Repair
NG
Refer to GROUP 54B ± Troubleshooting.
YES
Repeat the wiring check after the navigation unit becomes cool.
Replace the navigation unit.