BACK DOOR
SERVICE SPECIFICATION
Item
Back door handle play mm
SEALANT
Item
Waterproof film
SPECIAL TOOL
Tool
TROUBLESHOOTING
The central door locking (back door) is controlled by the Smart Wiring System (SWS). For troublesshooting,
refer to GROUP 54B ± Troubleshooting.
Section A ± A
A
A
BODY ±
Specified sealant
3M ATD Part No. 8625 or equivalent
Number
Name
MB990784
Ornament remover
ON-VEHICLE SERVICE
BACK DOOR FIT ADJUSTMENT
1. If the striker and latch mesh badly, move the striker forward
2. If uneven clearance is present between back door and
BACK DOOR HANDLE PLAY CHECK
1. Measure the back door handle play.
2. If the back door handle play is not within the standard
B
Back Door
Standard value
2.0 ± 8.0
Remark
Ribbon sealer
Use
Back door trim removal
and backward or right and left to adjust.
body, reposition the hinge and striker and/or change the
thickness of shim (change the number of shim) to adjust
the clearance.
Standard value (B): 2.0 ± 8.0 mm
value, check the back door handle and door latch assembly.
Replace if necessary.
42-33