A/T Control Component Check - Mitsubishi Pajero Pinin 1999 Workshop Manual

AUTOMATIC TRANSMISSION ±
Input shaft speed sensor
On-vehicle Service

A/T CONTROL COMPONENT CHECK

OVERDRIVE SWITCH CHECK
Refer to P.23-51.
WIDE OPEN THROTTLE SWITCH CHECK
Refer to P23-51.
ACCELERATOR PEDAL POSITION SENSOR (APS)
CHECK
Refer to GROUP 13A ± On-vehicle Service.
INHIBITOR SWITCH CHECK
Refer to P.23-37.
STOP LAMP SWITCH CHECK
Refer to GROUP 35 ± On-vehicle Service.
VEHICLE SPEED SENSOR CHECK
Refer to GROUP 54 ± On-vehicle Service.
DUAL-PRESSURE SWITCH CHECK
Refer to GROUP 55 ± On-vehicle Service.
FREE WHEELING ENGAGE SWITCH CHECK
Refer to GROUP 26 ± On-vehicle Service.
INPUT SHAFT SPEED SENSOR CHECK
1. Disconnect the input shaft speed sensor connector.
2. Measure the resistance between terminals 9 and 10 of
the input shaft speed sensor connector.
Standard value: 620
3. If the resistance is not within the standard value, replace
the input shaft speed sensor.
60 Ω (at 20 C)
23-41