Busch-Jaeger Busch-SmartTouch ST/U10.1.11-811 Product Manual page 84

Commissioning of the KNX function via BJE DCA SmartTouch 10 (from
Display brightness [%]
■
Options:
The parameter is used to set the display brightness in %.
Notice
The parameter is only available if the "Brightness is adjusted to the ambient
light" parameter is deactivated.
Switch off the display after [min]
■
Options:
The parameter is used to set after how many minutes the display is switched off.
Switch off the display when the room is dark
■
Options:
When the checkbox is activated, the display is switched off when the room is dark.
Brightness value for interpretation as dark
■
Options:
The parameter is used to specify the brightness value below which the brightness is interpreted
as dark (1 = dark - 5 = bright).
Notice
The parameter is only available if the parameter "Switch off the display when the
room is dark" is activated.
Switch off after [min] of darkness
■
Options:
The parameter is used to specify after how many minutes of darkness the display switches itself
off.
Product manual 2CKA001473B5342
10 - 100
1
2
5
10
15
30
Activated
Deactivated
1 - 5
1
2
5
10
ETS5)
│84