Commissioning of the KNX function via BJE DCA SmartTouch 10 (from
9
Commissioning of the KNX function via BJE DCA
SmartTouch 10 (from ETS5)
Commissioning the Busch-SmartTouch
SmartTouch 10.
9.1
Integration into the KNX system (ETS)
Notice
The device meets KNX guidelines and can be used as product of the KNX
system. Detailed expert knowledge for understanding by means of KNX training
is assumed, especially with regard to the commissioning software ETS.
9.1.1
Prerequisites
DCA version
The minimum requirement is the use of the BJE DCA SmartTouch 10.
ETS version
The minimum requirement is the use of ETS from version 5.
SD card
The following SD card types are supported:
Type:
Capacity:
File System:
Notice
■
■
■
Product manual 2CKA001473B5342
®
via the plug-in ETS5 commissioning tool BJE DCA
Every commercially available SD card is supported
4 - 128 GB
exFAT / FAT32
It is recommended to use SD cards from ScanDisk, Kingston and Transcend
that have been fully tested and checked.
While pictures are being recorded or copied on the card, do not remove the
SD card nor restart the panel. Otherwise, pictures may not be displayed.
Busch-Jaeger is not liable for the performance of an SD card.
ETS5)
│68