Table of Contents
Advertisement
Commissioning of the KNX function via BJE DCA SmartTouch 10 (from
Sending time and date
■
Options:
The parameter is used to specify the time interval at which the device sends the date and time.
Notice
The parameter is available only when parameter "Send/receive time and
date" is set on "Only sending".
First day of the week
■
Options:
The parameter is used to specify the first weekday.
Lat. [dd.dd][+ = North, − = South]
■
Options:
The parameter is used to set the geographic latitude for the location of the device (90° North to
90° South)
This setting is important for the astro function.
Notice
Whether a dot or a comma is to be used as decimal separator depends on the
system. If a wrong separator is used, the decimal places cannot be entered as
desired, or the value entered is replaced by a standard value after the entry.
If the entry is made in decimal degrees for example, the angular minutes are specified as
number of decimal places: 1 degree corresponds to 60 minutes.
Product manual 2CKA001473B5342
Every minute
Every hour
Every 12 hours
At 00:00
At 00:02
At summer/winter time changeover
At 00:00 + summer/winter time changeover
At 00:02 + summer/winter time changeover
Saturday
Sunday
Monday
Setting option from +90.00 to -90.00
ETS5)
│80
Advertisement
Table of Contents
