Table of Contents
Advertisement
Under "Other settings" you can configure the settings described in the following.
Pos.
[1]
Product manual 2CKA001473B5342
Commissioning via Busch-free@home®
Description
Parameters
User language
Acoustic feedback
Volume of acoustic feedback
[%]
Colour scheme
Brightness for switching to
dark mode
Activating automatic return to
the start page
Activating automatic return to
the start page [s]
Adjusting the brightness to
the ambient lighting
LED switch-on brightness
night [%]
LED switch-on brightness
day [%]
Switch-off delay of display
Switch off the display when
the room is dark
■
Brightness level for
the interpretation as dark
Switch off after the start of
darkness
Using the proximity sensor
for switching the display
Sensitivity of proximity
sensor
Haptic feedback
Screensaver
Screen-saver mode
User language in which the information is shown on
the display.
Activation or deactivation of acoustic feedback
when using the display.
The parameter us used to set the volume of the
acoustic feedback.
The parameter is used to set the colour scheme
from "Bright" to "Dark".
The parameter is used to specify the brightness
value from which the display switches over to dark
mode.
This parameter is use to activate or deactivate the
automatic return to the start page.
This parameter is used to set the the number of
seconds after which the display view changes
automatically to the start page.
By activating or deactivating the parameter, the
automatic adjustment of the display brightness to
the ambient brightness is activated.
Setting the LED switch-on brightness for night in %
via the -/+ buttons.
Notice: The parameter only functions when a time
profile with the application "LED day/night
switchover" is available. The device (channel) must
be linked with this application!
Setting the LED switch-on brightness for day in %
via the -/+ buttons.
Notice: The parameter only functions when a time
profile with the application "LED day/night
switchover" is available. The device (channel) must
be linked with this application!
Specifying the time the device changes into the idle
state.
Specifying whether the display is to switch off when
the room is dark.
Specifying the brightness level from which the
brightness in the room is to be perceived as dark.
Specifying whether the display is to switch itself off
after the start of darkness.
Specifying whether the proximity sensor is to be
used for switching the display.
The parameter us used to specify the sensitivity of
proximity sensor.
The parameter is used to specify at which point on
the display the haptic feedback is to take place.
Specifying the time at which the screen saver is to
be activated.
Specifying the form in which the screen saver is to
be displayed.
│61
Advertisement
Table of Contents
