Table of Contents
Advertisement
NOTICE
erroneous operation.
A - Drive front cover
B - Keypad
8.
Set drive parameters in
■
Procedure B
This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
A - Insertion point for CN5 connector
B - Option
C - Included screws
D - Drive front cover
E - LED label
F - Keypad
Install the Option
Use this procedure to install the option.
YASKAWA SIEP C730600 83E CC-Link Technical Manual
Do not pinch cables between the front covers and the drive. Failure to comply could cause
Figure 5.8 Replace the Front Cover, Terminal Cover, and Keypad
Related Drive Parameters on page 23
Figure 5.9 Drive Components with Option
C - Drive terminal cover
for correct option performance.
G - Option modular connector CN1
H - LED Status Ring board
I - Connector CN5-A
J - Connector CN5-B (Not available for
communication option installation.)
K - Connector CN5-C (Not available for
communication option installation.)
5 Installation Procedure
17
Advertisement
Table of Contents
