A - Drive front cover
B - Keypad
2.
Put the LED label (B) in the correct position on the drive front cover (A).
A - Drive front cover
3.
Install the option (A) into the CN5-A connector (C) on the drive and use the included screws (B) to put it in
place.
A - Option
B - Included screw
4.
Use one of the remaining included screws (B) to connect one end of the ground wire (C) to the ground
terminal (D). Use the last remaining included screw (B) to connect the other end of the ground wire (C) to
the remaining ground terminal and installation hole on the option (A).
Tighten the screws to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
YASKAWA SIEP C730600 83E CC-Link Technical Manual
Figure 5.3 Remove the Keypad, Front Cover, and Terminal Cover
Figure 5.4 Put the LED Label on the Drive Front Cover
Figure 5.5 Install the Option
C - Drive terminal cover
B - LED label
C - Connector CN5-A
5 Installation Procedure
15