ICP DAS USA I-8014W User Manual page 9

250 ks/s, 16-bit, 8-channel differential/16-channel single-ended analog input module

Table of Contents

Input impedance adjustment

The I-8014W provides three input impedances such as 20k, 200k (default setting)

and 20M Ohm to meet system requirement. For most of cases, 200k is good enough.

Every time when the input impedance is changed on a calibrated module, it is

necessary to calibrate the module again, refer to

Calibration,

page17, if you are using

I-8000 or iPAC-8000 (MiniOS7 platform controller); if you use WinCE or WES

platform unit, refer to

page 28

for the calibration process.

I-8014W API User Manual, v 1.0.1, September 2011

E-mail: service@icpdas.com

Table of Contents