ICP DAS USA I-8014W User Manual page 18

To calibrate the I-8014W on i-8000 and iPAC-8000 unit
Step 1. Repeat from step1 to step3 in
a. Wire the power to control unit and control unit to PC.
b. Set the Differential / Single Ended jumper in differential position and
wire the calibration source to channel 0 by differential wiring.
c. Connect the meter as the following figure shows.
d. Turn on the control unit.
I-8014W API User Manual, v 1.0.1, September 2011
Copyright © 2011 ICP DAS Co., Ltd. All Rights Reserved.
Quick Start (See page
Calibration Source
14)
E-mail: service@icpdas.com
18