Solving Other Problems - MINOLTA-QMS Magicolor 2200 DP User Manual

Solving Other Problems

Symptom
Data was
sent to the
printer, but it
doesn't print.
Data indica-
tor stays on.
Printer
resets.
Printing
takes too
much time.
Solving Other Problems
Cause
An error message is
displayed in the message
window.
The transfer belt installa-
tion guide is not set cor-
rectly in the installation rail.
Too many typefaces are
being downloaded at the
same time.
Occasionally, software
applications interfere with
each other.
Downloading too many
typefaces can overload the
printer memory and cause
the printer to reset to
default.
The printer is set to a slow
printing mode (for example,
for OHP, thick stock, or
some other special kind of
media).
The printer is set to power
saving mode.
The printer memory is
insufficient.
Solution
Handle according to the message displayed.
Remove the transfer belt. Place the front end of the
intermediate transfer unit installation guide (2 locations)
correctly in the installation rail. Next, lightly push in the
unit. Carefully insert the transfer belt about 6 inches
(152.4 mm). Let go with your right hand that was holding
the top handle of the transfer belt, hold the front handle
with both hands, and carefully push in.
Make sure you have enough printer memory.
Some applications send a printer prep file to the printer
at the beginning of each document. When this occurs,
other prep files cannot be sent without resetting the
printer. Monitor your activities to see if there is a correla-
tion between your use of a certain application and the
printer resetting. If so, contact the application developer.
Additional memory (RAM) or a hard drive, which can be
used for font storage, is available and easily installed.
It takes more time to print with special media. When
using regular paper, make sure that the media type is
set properly in the driver.
It takes a little time for printing to start in power saving
mode. If you do not want to use this mode, disable it.
Add more memory.
71