Label (A/A4) - MINOLTA-QMS Magicolor 2200 DP User Manual

3
Attach the time-of-day clock
to the controller board.
Attention
Make sure that the pins on the time-of-day clock are properly aligned with
those in the receiving socket on the controller board. Damage to the time-of-day
clock and/or controller board could result if the pins are misaligned.
Locate the time-of-day clock socket on the controller board and the pin 1 notch or
a
printed label.
Locate the pin 1 indicator mark on the top of the time-of-day clock.
b
This mark may be a notch or a slight depression on one end of the clock.
Align this indicator mark with the pin 1 notch or printed label on the controller
c
board.
Gently press down on the time-of-day clock until it's firmly seated.
d
5
Reinstall the controller board.
Gently slide the controller board into the printer until it is fully seated, and then
tighten the two screws.
6
Reconnect all interface cables.
Time-of-Day Clock (Standard on Models EN and DP) 131