Maintaining The Printer - MINOLTA-QMS Magicolor 2200 DP User Manual

Maintaining the Printer

Handle the printer with care to preserve its life. Abuse may cause damage and void
your warranty. If dust and paper scraps remain on the inside or outside of the printer,
printer performance and print quality will suffer, so the printer should be cleaned
periodically. Keep the following guidelines in mind:
„
When cleaning the printer, always turn it off (O) and unplug it. Disconnect all
interface cables before cleaning inside the printer.
If you have an optional 5-bin mailbox installed, turn the printer off first, then turn
off the mailbox.
„
Either clean the printer before use, or allow time after unplugging it to allow the
fuser unit to cool down.
Attention
The fuser unit is hot. When the top cover is opened, the fuser unit
temperature drops gradually (one hour wait time).
„
Be careful when cleaning the inside or removing paper jams, as the fuser unit and
other internal parts may become very hot.
„
Do not place anything on the top of the printer.
„
Use a soft cloth to clean the printer.
WARNING!
Do not spill water or detergent into the printer; otherwise the printer will be damaged
and an electric shock may occur.
„
Never spray cleaning solution directly on the printer's surface; the spray could
penetrate through the air vents of the printer and damage the internal circuits.
Avoid using abrasive or corrosive solutions or solutions that contain solvents,
(such as alcohol and benzene) to clean the printer.
„
Always test any cleaning solution (such as mild detergent) on a small area of your
printer to check the solution's performance.
50 Maintaining the Printer