Loading Media - MINOLTA-QMS Magicolor 2200 DP User Manual

Notes

Loading Media

Take off the top and bottom sheets of a ream of
paper. Holding a stack of approximately 250
sheets at a time, fan the stack to prevent static
buildup for the paper before inserting it in a tray.
5 "
Do not fan transparency media.
Attention
Always load the media short edge first.
Attention
Do not mix media of different sizes, types, or weights, as this will cause
printer jamming.
„
When refilling media, first remove any media remaining in the tray. Stack it with the
new media, even the edges, then reload it. Although the magicolor 2200 was designed
40
„
If you touch the face of transparencies with your bare hands, print quality
may be affected.
„
Do not handle transparency media too much. Do not fan transparency media
before loading it. Resulting static electricity may cause printing errors.
„
Keep the media path clean. Transparencies are especially sensitive to a dirty
media path. If there are shadows on either the top or the bottom of the
sheets, see "Cleaning the Printer Interior" in the Maintenance Guide.
„
You can print continuously with transparencies. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous print and print one sheet at a time.
„
Check your application documentation for other information about printing on
transparencies.
O H P
Loading Media