Media Trays - MINOLTA-QMS Magicolor 2200 DP User Manual

Attention
Make sure that the ribbon cable connector and the controller board connector
pins are properly aligned. Damage to the controller board could result if the
pins are misaligned.
7
Press down gently but firmly on the cable connector until it is fully seated.
Attention
Do not push or pull with the ribbon cable. Use the cable connector.
8
Align the support posts with the holes on the controller board, and then press down
to secure the hard disk to the controller board.
So that you don't stress the board, press one corner at a time to secure the hard disk
to the controller board.
If you're installing DIMMs, go to the next section.
Otherwise, reinstall the controller board into the printer. Gently slide the controller
board into the printer until it is fully seated, and then tighten the five screws.
When you print a startup page (page 42), verify that the hard disk is listed.

Media Trays

The printer comes with a 500-sheet media tray (the upper tray—tray 2). The lower feeder
unit (standard on the DP model) has another 500-sheet optional media tray (the optional
tray—tray 5) that provides two main benefits:
„
Expanded flexibility to switch media size, color, and type without having to unload
and load media.
„
Increased media-feed capacity
Keep replacement trays close by, so you can easily change media by slipping one tray out
and another in.
Media trays accommodate only letter/A4/legal media.
128 Media Trays