Kanji Font Internal Ide Hard Disk - MINOLTA-QMS Magicolor 2200 DP User Manual

7
At the ftp> prompt, change to binary mode by typing
bin
8
At the ftp> prompt, send the fonts file to the printer's hard disk by
typing
put filename
where filename is the name of the installation file.
The printer's message window reads 1 Active Job to indicate that the fonts are
being downloaded to the hard disk. The ftp> prompt returns when the fonts have
finished loading.
9
At the ftp> prompt, end the ftp session by typing
quit
10
When the Disk light stops flashing and the printer's message window reads Idle
for at least 30 seconds, turn the printer off and then on again.
11
When the printer's message window reads Idle again, the fonts are ready to use.
The fonts should be listed in the Fonts section of the printer's Advanced Status page.
5 "
You may want to erase any installation files left on your computer (and/or workstation),
and then remove any temporary directories.

Kanji Font Internal IDE Hard Disk

The preformatted Kanji font internal IDE hard disk contains Kanji fonts and other files.
These fonts can be printed at a variety of point sizes and in different styles and resolutions.
After the Kanji hard disk is installed in your magicolor 2200, the Kanji fonts are available
for use just as if they were resident in the printer.
What's in the Kit?
„
Internal hard disk preformatted with the following Kanji fonts:
z
FutoGoB101-Bold
118 Kanji Font Internal IDE Hard Disk