IBM Flex System p270 Compute Node Installation And Service Manual page 69

About this task
Figure 26. Installing the battery
The following notes describe information that you must consider when replacing the battery in the
compute node.
v When replacing the battery, you must replace it with a lithium battery of the same type from the same
manufacturer.
v To order replacement batteries, call 1-800-426-7378 within the United States, and 1-800-465-7999 or
1-800-465-6666 within Canada. Outside the US and Canada, call your IBM marketing representative or
authorized reseller.
v After you replace the battery:
1. Set the time and date.
2. Set the network IP addresses (for compute nodes that start from a network).
3. Reconfigure any other compute node settings.
v To avoid possible danger, read and follow the following safety notice.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery
recommended by the manufacturer. If your system has a module containing a lithium battery, replace
it only with the same module type made by the same manufacturer. The battery contains lithium and
can explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps:
Procedure
Chapter 6. Installing and removing components
57