IBM Flex System p270 Compute Node Installation And Service Manual page 86

Figure 36. Locking the microprocessor into the tool
10. Holding the outside of the tool, lift the tool and microprocessor from the socket and place them at
an angle in the top cover of the microprocessor packaging that was opened in step 6 on page 69, as
shown in Figure 37.
Note: Setting the tool and microprocessor at an angle on the top cover of the microprocessor
packaging mekes it easier to pick up and place in the packaging after you replace the
microprocessor.
Figure 37. Placing the tool at an angle on the top cover of the packaging
74
Power Systems: IBM Flex System p270 Compute Node Installation and Service Guide