Humidity Option; Remote Temperature/Humidity Sensor; Serving Temperature Option; Overview Of The Wine Guardian Unit - Wine Guardian TTW018 Installation, Operation And Maintenance Manual

Humidity Option

An optional stand-alone humidifier comes fully assembled and tested for field installation. It
automatically adds moisture into the cellar by the evaporation of water over a distribution pad.

Serving Temperature Option

The factory configured serving-temperature option allows a Wine Guardian unit to control to an
extended temperature range from 42° F to 64° F (5°C - 18°C). Perfect for single to multiple
cabinet applications and small wine rooms in which consumption-temperature cooling is
preferred. It also allows the user to rotate wine stock and change the set point from season to
season, making it ideal for restaurants, wine bars, clubs, etc.

Overview of the Wine Guardian Unit

Refer to illustrations on page 14
– The cabinet is constructed of aluminum with a powder coated finish for corrosion protec-
Cabinet
tion and an attractive, maintenance-free appearance. Areas in contact with cold temperatures are
lined with insulation to prevent condensation.
Condensing Section
permanently lubricated, motorized impeller blower. This section also contains the compressor and
the electrical controls.
– Wine cellar air is circulated through the evaporator section by a direct drive,
Evaporator Section
permanently or lubricated motorized impeller blower. The large evaporator coil face area
eliminates condensate carry-over, reduces air pressure drop and optimizes heat transfer. A drain
pan is located directly below the coil to capture condensate and is fabricated from aluminum to
prevent rust and corrosion.
–All solid state electronic controls are connected internally and/or externally
Electrical Controls
through a phone cord-type connection. There is no need to open the chassis to access the factory
mounted and wired control. All internal wiring is in accordance with the National Electrical Code.
Wires are numbered and color coded to match the wiring diagrams.
– All Wine Guardian units are factory run-tested and checked for operational
Factory Tested
performance.
12
Humidifier Connection: You can locate the low voltage connection for field
optional remote humidifier on side of control panel on the wine cellar side of
the WG cooling unit. The optional humidifier comes pre-wired to fit directly to
this connection for the WG unit to control cellar humidity level desired.

Remote Temperature/Humidity Sensor

- Ambient air is circulated through the condenser section by a direct drive,