Performing A Pre-Installation Check; Locating The System; Power Cord Location - Wine Guardian TTW018 Installation, Operation And Maintenance Manual

✓ Where to locate the unit? It can be mounted flush with the racking or flush with the
wall on the wine cellar side.
✓ How to mount the unit? A mounting EasyMount™ kit is supplied.
✓ Locate the electrical power outlet close to the unit, in cellar or out. Do not use an
extension cord!
✓ Factory supplied power cord on condenser side of the unit. It is preferred to be on
the condenser side of the unit, the cord can be moved to accommodate wine cellar
side if need be.
✓ Does the condenser heat exhaust need to be ducted away? An optional kit is
available.
✓ Where to locate the thermostat, if remote interface control is ordered? Thermostat
should be located midpoint on a wall within the wine cellar and provide sufficient
access and exposure to airflow.
✓ How to install the drain line. Run to an open floor drain, container, or condensate
pump.
✓ Are all the parts here to complete the installation? Installation sleeve, gasket,
sealant fasteners

Performing a Pre-installation Check

✓ Check for the properly sized breaker as dictated by the system rating plate data.
✓ Is the cellar built with adequate insulation and vapor barriers?

Locating the System

Wine Guardian systems are typically installed at the user's eye level for ease of operation. The
Through-the-Wall system discharges warm air from its condenser end so this should be considered
when determining the location for the system. Locating the system adjacent to a mechanical room or
in close proximity to an exterior wall may be required if ducting the warm condenser air is being
considered. The warmer condenser air can be ducted up to 15 feet away (4.5 meters). Be sure to install
wire nuts onto the black and white wire leads at the condenser end, once the cord is removed.

Power Cord Location

You must then move the red voltage switch in the opposite direction to move the internal power
from the condenser side to the wine cellar side. See the steps below for relocating the power cord.
23
The power cord is factory wired on the condenser side of the system. If
you require the cord on the wine cellar side for plugging into an
available outlet, this can be accomplished by removing the 3-wire leads
(ground included) and moving the cord to the opposite side control
bracket and wire nutting the black, white and green wires to the factory
supplied leads. The wires must have the terminations cut off and
stripped first.
17