Mounting The Optional Remote Interface Controller (Wireless) - Wine Guardian TTW018 Installation, Operation And Maintenance Manual

Mounting the Optional Remote Interface Controller (Wireless)

Fig. 1
Fig. 2
Fig. 3
Fig. 4
43
1. Disconnect the controller wire from the side of Wine
Guardian unit and save for future use.
2. Plan on mounting the remote interface controller on
a solid surface away from doors, corners, air outlets,
drafts or heat generating equipment. Do not mount
the remote interface controller directly on an outside
wall, a wall adjacent to a boiler room, or other hot
area. Use a piece of foam insulation behind the
sensor to insulate it from a hot or cold surface. The
recommended height is four to five feet above the
finished floor.
3. Unscrew and remove the back plate from the
Remote Interface Controller (Fig. 1)
4. Place the back plate against the wall and mark the
mounting points at the desired location. (Fig. 2)
5. Drill two one-eighth inch holes and insert anchors
within the mounting surface. Anchors may not be
required if securing to a wall stud or racking system.
Insert the screws into the holes and test fit the
backing plate for mounting to ensure it mounts
easily onto the two screws and slides down onto the
slotted openings freely (Fig. 3)
6. Reattached the back plate to the Remote Interface
Controller. (Fig. 4)
7. Insert the three AA batteries.
(only applicable with wireless installations)
8. The system will automatically acknowledge a
wireless device (Remote Interface or Remote
Sensor). Go to Setting "30" to define the Remote
User Interface use.
9. Attach controller to the wall.