Wine Guardian TTW018 Installation, Operation And Maintenance Manual page 34

Defrost cut-out
temperature
Defrost check
interval
Room
temperature
offset
RH offset
34
Setting 11

Press "Settings" button to advance to
Setting 11.

Press the "Up" or "Down" arrow buttons
to adjust to the desired setpoint. This
setting is adjustable from 35°F to 50°F.
Factory default is 40°F.
Note: This setpoint must be 1°F/°C higher
than setting 10.
Note: If °C is selected and then switched
back to °F the default cut-out will change
to 41°F.
Setting 12

Press "Settings" button to advance to
Setting 12.

Press the "Up" or "Down" arrow buttons
to adjust to the desired setpoint. This
setting is adjustable from 30 min at 0
(zero), 1 hour at 1, and then in 1 hour
increments up to a maximum of 12 hours
at 12.
Setting 13

Press "Settings" button to advance to
Setting 13.

Press the "Up" or "Down" buttons to
adjust to the desired set point. Maximum
setting is +5°F, minimum setting is -5°F.
Factory default is zero (0).
Room temperature offset changes the
actual display reading (temperature only)
by the value of this setting.
Example: Sensor reading = 55°F (13°C)
Setting 13 set to +4
Display reading = 59°F (15°C)
Setting 14

Press "Settings" button to advance to
Setting 14

Press the "Up" or "Down" buttons to
adjust to the desired setpoint. This setting
allows the adjustment of %RH reading by
+/-10%. Factory default is 0%RH.