Power Frequency < / = 460 Hz (For Isohr1685D-925); Single-Pole Operation" - Isohv1685D Only; Inputs - Bender ISOMETER iso1685DP-425 Manual

8.2 (1.5) Power frequency < / = 460 Hz (for isoHR1685D-925)
•<= 460 Hz
•> 460 Hz
8.2 (1.6) „Single-pole operation" - isoHV1685D only
The isoHV1685D-425 can be used in applications up to DC 6 kV. The prerequisite for this is the
center tap / the center tapping, to which the device is connected single-pole.
tion" on page 23 Connection screen
• ein
• aus
8.2

(1.6) Inputs

The ISOMETER® provides 2 digital inputs (I1, I2) that are freely configurable.
8.2 (1.6.1) Digital 1
The following parameters can be set for the digital input:
8.2 (1.6.1.1) Mode
The operating mode for the digital input can be set to the following values:
Active high
+
+
24 V
-
-
Active low
+
+
24 V
-
-
46
The power frequency is set to max. 460 Hz.
The power frequency is set to over 460 Hz.
4)
Die Funktion wird aktiviert.
Die Funktion wird deaktiviert.
An event is carried out on the falling edge of the digital input (low to
high). Response time t(on)/t(off ) after a switch-on signal.
1
I1/I2
I1/I2
0
< t(on)
An event is carried out on the falling edge of the digital input (high to
low). Response time t(on)/t(off ) after a switch-off signal.
1
I1/I2
I1/I2
0
< t(on)
Reaktion
Impuls on
t(on)
Reaktion
t(on)
isoxx1685Dx-x25_D00272_07_M_XXEN/09.2022
Settings
(5.2 "Connec-
Reaktion
t
Reaktion
Impuls on
t