MITSUBISHI CNC
III Functional Specifications
7.4 Others
7.4.1 Handy Terminal Connection
M720VW
M system
△
L system
△
Machine operations, such as setup operations, are possible at hand by using a handy terminal.
(1) Machine operation using manual pulse generator, jog and inching
(2) Displaying CNC status such as machine position
(3) Displaying PLC messages
(2 languages x 20 one-byte characters x 256 messages can be stored.)
(4) Emergency stop button
(5) Screen display covering 4 lines x 20 characters (64 dots lengthwise x 192 dots widthwise)
(6) Operation valid or invalid switch for 3 positions (OFF-ON-OFF)
(7) Setting for tool compensation, workpiece coordinates, etc.
(8) Creating display data using NC Designer (handy terminal)
(a)
X
120.935
(b) =10
Y
100.000
(c) =5
Z
50.050
Handy terminal
(Note 1) CNC outputs the data received from the handy terminal to the PLC interface.
CNC transmits the data of which PLC sets in the PLC interface to the handy terminal.
Thus, the machine tool builder must create a PLC program corresponding to the handy terminal.
(Note 2) Before using the handy terminal, it is necessary to customize the display area configuration, key
input, communication conditions with CNC, etc.
(Note 3) This function cannot be used in combination with the serial GPP communication.
III - 96
M730VW
M750VW
M720VS
△
△
△
△
NC Designer Handy terminal
M730VS
M750VS
―
―
―
―
―
―