Table of Contents
Advertisement
(1) During the high-speed machining mode I, the blocks are pre-read. If the length of the block is
sufficiently short in respect to the command speed, and enough to be completed with one
interpolation calculation, several blocks may be combined and converted into a block length
that can be completed with one interpolation.
(c)
(a) Program command
(b) Command when program commands are combined and converted
(c) Command in high-speed machining mode I
(2) Override, maximum cutting speed clamp, single block operation, dry run, manual interruption,
graphic trace and high-accuracy control mode are valid even during the high-speed machining
mode I.
: (a)
: (b)
M700V Series Specifications Manual
12 Program Support Functions
III - 271
Advertisement
Table of Contents
