Mitsubishi Electric M700V Series Manual page 22

MITSUBISHI CNC
III Functional Specifications
(Example)
G60 G91 X100. Y100. ;
(a)
(C)
X100.
(a) Interim point
(C) Current position
(E) End point
(Note 1) The processing of the above pattern will be followed even for the machine lock and Z-axis
command cancel.
(Note 2) On the creep distance, the tool is moved with rapid traverse.
(Note 3) G60 is valid even for positioning in drilling in the fixed cycle.
(Note 4) When the mirror image function is on, the tool will be moved in the reverse direction by mirror
image as far as the interim position, but operation over the creep distance with the final advance
will not be affected by the mirror image.
III - 20
(E)
Y100.
The rapid traverse rate for each axis is the value set with parameters as the G00
speed.
The vector speed to the interim point is the value produced by combining the
distance and respective speeds.
The creep distance between the interim and end points can be set
independently for each axis by parameters.