MITSUBISHI CNC
III Functional Specifications
12.1.8.3 Mixed Control (Cross Axis Control)
M720VW
M system
―
L system
△
This function enables any axis to be replaced by another axis between part systems.
This makes it possible to perform operations which are not possible with regular axis configurations: for
instance, tools which are provided only on part system 1 can be used for machining on part system 2.
This manual contains descriptions where part system Nos. have been added after the axis names in order to
identify which part system the axes belong to (such as X1). In terms of designating the program commands,
however, a single letter is used to designate the axis address just as before.
The mixed control (cross axis control) has two types depending on the command method:
mixed control (cross axis control) I (G command) and mixed control (cross axis control) II (command with
PLC signal).
Switching C1 axis control from the 1st part system to the 2nd part system
III - 252
M730VW
M750VW
―
―
△
△
$1
X1
Z1
C1
Z2
X2
$2
M720VS
M730VS
M750VS
―
―
△
△
$1
X1
Z1
C1
$2
―
△
Z2
X2